|
Contents > Procedures
3.6. Using Command Line Parameters
Active@ UNERASER for DOS supports a set of command line parameters.
To view them and their definitions, type:
A:\>UNERASER -?
Table 3-4 Command Line Parameters
|
Parameter
|
Description |
Note |
|
|
No parameter |
The DOS Interactive screens will appear. |
|
-? |
Question mark |
The table of parameters will appear. |
|
-lba |
Force LBA mode for access to all detected HDDs |
|
|
-lba=N |
Force LBA mode for access to the specified HDD |
N=[80h,81h,82h,83h] |
|
-restoreMBR=N |
Virtually restore MBR from the backup for a specified drive |
N=[80h,81h,82h,83h] |
|
-ignoreMBR=N |
Do not load MBR information for the specified drive |
N=[80h,81h,82h,83h]. It allows scanning of existing or damaged partitions |
|
-imageN=PATH |
Create an image for the physical drive (Professional version
only) |
N=[80h,81h,82h,83h] PATH=<drive>:\\<path\\> |
Previous < Contents >
Next
|
